√在线天堂中文最新版网,97se亚洲综合色区,国产成人av免费网址,国产成人av在线影院无毒,成人做爰100部片

×

distribution of velocities造句

"distribution of velocities"是什么意思   

例句與造句

  1. On the design case , the distribution of velocity , temperature and pmv - ppd of workstation are well
    在設計工況,工作區溫度、速度、 pmv值分布均勻。
  2. The predicted distributions of velocities are in good agreement with experiment values , from which right results can be concluded . the results give the flow status directly
    將計算結果與前面的實驗結果相比,證明計算結果正確,并給出了直觀的速度分布圖。
  3. 2 . the distribution of velocity and concentration field are gained by numerically simulating the pulsed non - steady flow field of riverway equipped with navigation lock , after salt water is drained it into
    2 、對船閘河道的脈沖狀非穩態流場進行數值模擬,得出將鹽水排放入后河道的濃度場和速度場分布。
  4. Using the above method , the problem of 3 - d field of velocity and pressure in the pump can be solved . then get the map of distribution of velocity and pressure field and analyze them
    用上述方法求解無堵塞泵葉輪內部三維湍流速度場和壓力場,給出了速度和壓力云圖,并對數值計算結果進行了分析和研究。
  5. To analyze the hydrodynamic structure of the estuary , 3d k - numerical model with curvilinear fitted coordinate has developed . the distribution of velocity and turbulent exchange coefficient at different time has obtained and analyzed
    紊流模型對測驗河段進行計算,得到特征時刻該潮汐河口段的水力要素及垂向紊動混合系數的分布。
  6. It's difficult to find distribution of velocities in a sentence. 用distribution of velocities造句挺難的
  7. The distributions of velocity vector , vorticity . turbulent kinetic energy and some other detailed flow information in the field are obtained . the influence of electric field on the flow field is discussed and gives a deep insight on it
    3 、首次采用piv技術對荷電噴霧射流流場進行了測量,獲得了整個流場的瞬時速度、湍能、渦量等信息分布圖,研究了流場特性隨充電電壓的變化情況。
  8. By the numerical simulation , calculate the distribution of velocity ^ temperature and contaminant concentration of air in the room under different modes of air flow organization , and through analysing the outcomes of simulation , draw some conclusions
    對常見的辦公室環境,不同送回風方式下的室內空氣的速度、溫度及污染物濃度的分布進行模擬計算,并對模擬結果進行分析,得出結論。
  9. Then , we caculate the dynamic character of the reflective mtn cell with the optimized parameter , give out the distribution of velocity , twist angle and tilt angle at the midle of the mtn cell when switch on or off in consideration of the backflow
    并針對選定參數的mtn液晶盒作了動力學上的計算。文中分別了給出mtn盒在加電壓和撤電壓時,引流效應對反射率的影響,并比較指向矢,速度,中間層的傾斜角等參量分布的情況。
  10. Based on this theory , some experiments were done on two different hermetic cabins of two different man - made satellites . the results of the experiments give us the distribution of velocity . compare the results to the requested , and some suggestions can be given
    在該理論的指導下,分別對兩個型號衛星密封艙的流動情況進行了實驗研究,實驗結果給出艙內的速度分布情況,并與要求的速度分布比較,由此對設計方案提出合理建議。
  11. Abstract : focused on the metal plastic forming of valve bodies for power plant boiler , a new process named “ shear extrusion ” is described in this paper . the numerical simulation analysis is carried out by using the 3 - d deform software to predict the distribution of velocity , stress , strain and temperature fields during the forming process and the flow law of metal . then the numerical simulation results are testified by simulative experiment . finally , large - size valve bodies have been successfully formed by the screw press
    文摘:針對電站鍋爐用大型截止閥體的制造新工藝? “剪切擠壓” ,利用數值模擬的方法對剪擠工藝進行研究,得到了成形過程中速度、應力、應變及溫度場等的分布及金屬流動規律,并通過物理模擬實驗進行了驗證,進而為獲得閥體剪擠制造的最佳成形工藝參數提供可靠依據。
  12. Secondly , the paper tells about how the two - phase theory was used in the analysis of the distribution of the velocity of two - dimension open channel flow and the general model of the flow with pushing layer . an equation of the distribution of velocity was get from this analysis and was proved to be reasonable
    接著又闡述了兩相流的基本理論用在明渠二維恒定均勻兩相流動中的情況,以及按挾帶推移質水流的概化模式,導出的垂線流速分布公式,這已被水槽實驗驗證為合理。
  13. By comparing the dry plate pressures drop and distributions of velocities simulated on single valve with those of double valves , it was found that there was intense turbulence in the flow fields around fixed - valve , there were eddy areas between valve side orifices and tray wall , there were eddies above the valves too , these led to the complex behaviors of gas perforating valve , these had a great effect on the gas - liquid mass transfer process . at the same time , in order to prevent the disadvantageous effect of gas between one valve with another on the gas - liquid mass transfer , it was very effective to change the fields of gas perforating valve by folding the edges of valve
    通過對數值模擬得出的單閥和雙閥塔板的干板壓降及流場速度分布分析對比后發現,固定閥周圍流場存在較強的湍動,閥側孔與塔板壁面區域以及閥體的上方空間存在明顯的渦流區,使氣體穿閥后的行為變得復雜,并對氣液傳質過程產生重大影響;模擬結果表明,為防止和削弱固定閥間的對沖造成的“死區”對傳質帶來的不利影響,通過折邊來改變氣體的氣路是非常有效的,模擬值與實驗值基本得到吻合。
  14. The additional flow is formed by the device of dentoid baffle , and the application of the device of dentoid baffle cooperated with a stilling basin has been investigated by systematic model tests . based on the research results , the hydraulic problems such as the characteristics of hydrodynamic pressure and cavitation on the head of the denotid baffle , the properties of flow under the condition that the device of denotid baffle is used with a stilling basin , the hydraulic computation about a stilling basin , the estimation of energy dissipation and its various affection factors , the mechanism and effect of energy dissipation , and distributions of velocity and pressure and aerating concentration , etc , have been analyzed ; the method and step of hydraulic design of device of denotid baffle by which the additional flow is produced has also been proposed
    文中利用齒墩設施實現附加射流,對齒墩設施與消力池聯合應用進行了大量的和系統的模型試驗,分析研究了中低佛勞德數條件下,齒墩墩頭的動水壓強及空化特性,齒墩設施與消力池聯合應用時的流態特性,消力池的水力計算,消能量的估算及其各種影響因素,消能機理和效果,消力池內的流速、壓強特性,摻氣濃度分布等水力學問題,并提出了實現附加射流齒墩設施的水力設計方法和步驟。
  15. A " saddle " shape appears in the curve of relationship between smd ( sauter mean diameter ) and charging voltage , the droplets " size distribution fluctuates with the change of charging voltage . the influence of electric field on flow field is apparent . the distribution of velocity and turbulent energy , structure and size of vortex appear different changes with the increase of voltage of charging
    索太爾粒徑隨電壓的變化曲線中出現“馬鞍”現象,粒徑的分布情況隨電壓的升高出現波動性變化;電場對流場的作用明顯,速度與湍能的分布及渦的結構等流場特性隨電場的改變均有不同規律的變化。
  16. The convective term is solved by ausm + ( a sequel to ausm which means " the advection upstream splitting method " ) . the 7 species 8 steps model and 7 species 7 steps model of hydrogen / air is used in the hydrogen reacting flowfield , the 9 species 5 steps model of methane , the 10 species 10 steps model of ethane and the 10 species 13 steps model of kerosene are used in the hydrocarbon reacting flowfield , the results of the distributions of velocity , mach number , pressure , static temperature , total temperature , species mass fraction and the combustion efficiency are gained , and the numerical results of the pressure of hydrogen and methane are compared with those of the experiment
    計算中通量項采用ausm +通量分裂格式,氫反應流場采用氫/空氣的七組元八方程模型和七組元七方程模型,碳?xì)浞磻?yīng)流場采用甲烷的九組元五方程模型、乙烯的十組元十方程模型和煤油的十組元十三方程模型,得出了超燃發動機燃燒室流場的速度、馬赫數、壓力、靜溫、總溫和組元質量分?jǐn)?shù)分布及燃燒效率等性能參數,其中氫和甲烷的計算壓力分布與實驗結果進行了比較。
  17. 更多例句:  下一頁

相鄰詞匯

  1. "distribution of threads"造句
  2. "distribution of time"造句
  3. "distribution of toxicant"造句
  4. "distribution of values"造句
  5. "distribution of variance"造句
  6. "distribution of velocity"造句
  7. "distribution of ventilation"造句
  8. "distribution of voltage"造句
  9. "distribution of water temperature"造句
  10. "distribution of wave energy"造句
桌面版繁體版English日本語

Copyright ? 2025 WordTech Co.